Audi: 06-13 A3, 10-13 A3 TDI; (8P) - KW Variant 1 Coilover Kit - KW Suspensions

KW SUSPENSIONS V1 'INOX-LINE' COILOVER KIT

KW Variant 1 ‘INOX-LINE’ Coilover Kit is KW Suspension’s entry level performance coilover kit. The high quality inox-line stainless steel coilover struts, corrosion resistant springs, bump stops and dampers are optimally tuned resulting in a balanced and sporty feel, specific to vehicle application, and designed for long lasting driving pleasure.

Maximum lowering can be achieved with KW Variant 1 ‘INOX-LINE’ coilovers that, within an approved lowering rate, ensure proper functioning suspension and adequate travel when the vehicle is lowered. Ride height continues to be easily adjustable, even after years of use, due to the dirt resistant trapezoid thread and composite adjustment collar.

The pre-configured vehicle specific damper setup and spring rate increase driving pleasure with an optimal balance of comfort, sportiness, practicality and safety. Vehicle body roll is reduced during compression to give the benefit of more genuine and direct handling while driving.

The KW Variant 1 ‘INOX-LINE’ Coilover Kit has been developed and manufactured in-house at KW’s facility in Germany, specifically for the particular vehicle. The V1 coilovers undergo comprehensive stress testing and fine tuning, as do all KW coilovers, at their 7-post Driving Dynamic Test Center and on the Nürburgring.

FEATURES & BENEFITS

• Customized suspension lowering
• ‘Inox-Line’ stainless steel struts
• Corrosion resistance springs
• Bump stops
• Dirt resistant trapezoidal thread
• Reduced body roll
• Pre-configured damping
• Technical Component Report
• KW Suspension limited lifetime warranty

MODEL FITMENT

*NOTE

• Fits vehicles with a clamp diameter of 54.6mm on the front axle.
• Valving is adjusted by adjustment knob, rebound is only adjustable if the top of the piston rod is accessible. This will depend on the design of the vehicle
• For cars which have electronic dampers, these will need to be shut down.  Specific electronic damper shut-downs are available from KW.
• Height adjustable front and rear axles (front axle threaded strut housings, rear axle adjustable springs and dampers).

**NOTE

• Fits vehicles with a clamp diameter of 54.6mm on the front axle.
• Valving is adjusted by adjustment knob, rebound is only adjustable if the top of the piston rod is accessible. This will depend on the design of the vehicle.
• Vehicles equipped with electronic damper control, the EDC needs to be disabled.  Disable modules are available through KW.
• Front height adjustable by threaded shock bodies.
• Rear height adjustable by adjustable spring perch.